iBoot-G2S Quick Start
© 2018 Dataprobe Inc.
V180802N
What’s Included
•
iBoot-G2S Unit
•
Power Input Cable for North America
•
Power Outlet Cable for North America
•
Network Cable
•
USB Cable
Available Online at
dataprobe.com/support-iboot-g2s
•
Complete Product Manual
•
Device Management Utility
•
Latest iBoot-G2S Firmware
•
Software Developer Tools
Connections
1. Connect Network.
iBoot-G2S
supports dual 10/100 Connect one to the
network using the cable supplied, or other suitable unshielded twisted pair (Cat 5)
cabling. Optionally, connect the other to a networked device. When power is
connected to the iBoot-G2S, the green LEDs on the network connectors indicates
when the network connection is properly established.
2.
Connect Powered Device.
Connect the device to be powered ON and OFF
to the IEC receptacle marked A/C Outlet. An IEC-320 to North American (NEMA 5-
15) power cord is included for connecting the iBoot outlet to the device to be
controlled. If the device has a power switch, turn it on, to allow iBoot-G2+ to control
the power.
Make sure that the combined load of all controlled devices
does not exceed 12 Amps for 105-125VAC or 10 Amps for 210-
240VAC.
3. Connect Power Mains
Connect the supplied power cord to the connector
labeled AC Input, and the other end to your AC source. If a power cord with a
different terminating plug is required, be sure it is properly rated and meets all the
required local electrical standards.
Web Browser Access
Factory Default IP Address: DHCP Set or 192.168.1.254
Factory Default Security Credentials:
Role
Username
Password
Administrator
admin
admin
Discover and/or Set the IP Address
If you network supports DHCP, the IP address of the iBoot will be
automatically assigned. Find the IP Address of the iBoot using either from the
DHCP Router/Server or use the Dataprobe Device Management Utility (DMU),
available at
dataprobe.com/support-iboot-g2s
. See Page 2 for more in the
DMU.
Point your browser to the IP Address of the iBoot, then enter the Administrator
Username and Password to access the complete setup features. Once the
user is validated, the Control and Status is displayed.
To control the power, select the Main Outlet checkbox, and then click on the
appropriate power button. During power cycling, the Power Status bar will
indicate the temporary status, with a blue background. Once the cycle is
complete, the status bar will revert to its original condition.
Quick Start Guide
Fig.1 Connect Network
Fig. 2 Connect Device
Fig. 3 Connect Power
Fig. 4 Status and Control Page
Содержание iBoot-G2S
Страница 4: ......
