Datamax H Class, Руководство оператора

Страница: 60 / 160

52
REDUNDANCY
LEVEL * Ensures integrity by setting the number of consecutive, identical decodes that are
required for the bar code to be considered readable. For example, if set to three
times, the bar code will not pass until the same values have been decoded three
times in succession.
The setting range is 1 – 6, and Auto.
Notes: (1) Depending upon the print speed, higher verification levels may
cause erroneous failures when scanning multiple bar codes or bar
codes that are small in height.
(2) When ‘Auto’ is selected, the printer defaults to a MIN READABLE
HEIGHT setting of 1/16.
2 Is the Default Setting.
SET DEFAULTS
* Resets the Scanner to the default values, as follows:
Mode = Auto
Barcode Count = 00
Min Readable Height = Disabled
Redundancy Level = 2
RFID Controls the programming and verification of RFID tags, where:
RFID MODULE
Sets the mode of RFID operation:
Note: If trying to enable RFID operation without option's presence (installed or
detected), the printer will initially respond with a DISABLED message.
DISABLED Disables the option.
HF Selects the High Frequency RFID option.
UHF MULTI-
PROTOCOL Selects the Ultra-High Frequency RFID option.
RFID POSITION
* (1.10 - 4.00 INCHES)
1.10 Is the Default Setting.
HF SETTINGS * Sets HF tag parameters:
TAG TYPE Sets the tag type:
ISO 15693
TI
PHILIPS
ST LRI512
ST LRI64
AFI VALUE (00 - FF)
AFI LOCK ENABLED / DISABLED
DSFID VALUE (00 - FF)
DSFID LOCK ENABLED / DISABLED
EAS VALUE (00 - FF)
AUDIO
INDICATOR ENABLED / DISABLED
ERASE ON
FAULT ENABLED / DISABLED