Datalogic SC4000, Справочное руководство

Страница: 37 / 59

ELECTRICAL CONNECTIONS
5
5.6 DATA SOURCE AUXILIARY INTERFACE
The Data Source Auxiliary Interface available on the 9-pin connector below can be used for
configuration through Genius™ of an optional external reading device connected through the
25-pin connector.
5 1
6 9
Figure 31 - 9-pin D-Sub Female Connector
With reference to the 9-pin connector of Figure 31, the following pins are used to connect the
Data Source Auxiliary Interface:
Pin Name Function
2 TX Data Source Aux Interface Receive Data
3 RX Data Source Aux Interface Transmit Data
5 SGND
Signal Ground
1, 4, 6, 7, 8, 9 N.C.
RX TX
Reference
USER INTERFACE
Figure 32 – Data Source Auxiliary Interface Connections
5.7 INPUTS
There are two optocoupled polarity insensitive inputs available on the SC4000: Input 1
(External Trigger Input) and Input 2, a generic input. These inputs are typically used when
SC4000 is an ID-NET Master in a Synchronized network.
These inputs are optocoupled and can be driven by both NPN and PNP type commands.
NOTE
Polarity insensitive inputs assure full functionality even if pins A and B are
exchanged.
29