Datalogic QuickScan QM24 series, Руководство по продукции

Страница: 64 / 314

Enter/Exit Programming Mode
54 QuickScan™ I QD24XX/QBT24XX/QM24XX
Global Prefix/Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the bar code data, also
called a header) and/or as a suffix (in a position following the bar code data, also called a
footer). See page 245 for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar code above to place
the unit in Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” bar code fol-
lowed by the digits (in hex) from the Alphanumeric characters in Appendix D, Keypad repre-
senting your desired character(s). If less than the expected string of 20 characters are selected,
scan the ENTER/EXIT bar code to terminate the string. Exit programming mode by scanning the
ENTER/EXIT bar code again.
$CLFPR
Set Global Prefix
$CLFSU
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)