Datalogic PowerScan Series, Руководство по продукции

Страница: 288 / 411

ENTER/EXIT PROGRAMMING MODE DISPLAY AND KEYBOARD FEATURES
272
POWERSCAN™ PD/PM/PBT9600
BARCODE/KEY DIFFERENT DATA FORMAT
If this parameter is enabled, barcode and keyboard entered data can be formatted sepa -
rately. More specifically: if this parameter is disabled, barcode and keyboard data will
share the same Header and Terminator defined using “Set Barcode Header” and “Set
Barcode Terminator” below. If this parameter is enabled, keyboard entered data are
treated differently, as their format must be programmed through the parameters Set
String Header, Set String Terminator, Set Key Sequence Header and Set Key Sequence
Terminator.
Set Barcode Header
Sets the header for barcode and keyboard composed strings.
Set Barcode Terminator
Sets the terminator for barcode and keyboard composed strings.

Disable
$CPWDF00
$CPWDF01
Enable
Set barcode header
$CPWBH
To configure this feature, scan the ENTER/EXIT PRO -
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in Appendix G, Keypad . The digits must
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string. If the first 2 digits are 0, the feature is dis -
abled. End by scanning the ENTER/EXIT bar code
again.
Set barcode terminator
$CPWBT
To configure this feature, scan the ENTER/EXIT PRO -
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in Appendix G, Keypad . The digits must
be the hexadecimal ASCII representation of the
desired characters.
If less than the expected string of 16 characters are
selected, scan the ENTER/EXIT bar code to terminate
the string. If the first 2 digits are 0, the feature is dis -
abled. End by scanning the ENTER/EXIT bar code
again.