Datalogic PowerScan PD9530, Руководство по продукции

Страница: 268 / 362

Enter/Exit Programming Mode
258 PowerScan™ PD9530/PBT9500/PM9500
Set String ID
Sets the identifier of the predefined strings.
$CPWEB
Set String ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 6 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
.
The ID characters must be represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this feature
is disabled. End by scanning the ENTER/EXIT bar code
again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
Set String Header
Sets the header of the predefined strings.
$CPWED
Set String Header
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 32 digits from the Alphanumeric charac-
ters in
Appendix D, Keypad
.
The digits must be the hexadecimal ASCII representation
of the desired characters. If less than the expected
string of 16 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL