Datalogic Matrix 120, Руководство по продукции

Страница: 21 / 188

STEP 3 - X-PRESS CONFIGURATION
PRODUCT REFERENCE GUIDE 7
5. Exit the Aim function by pressing the X-PRESS push button once. The aiming sys-
tem turns off.
Setup
Learn
1. Enter the Setup function by pressing and
holding the X-PRESS push button until the
Setup LED is on.
2. Release the button to enter the Setup
function. The Setup LED will blink until the
procedure is completed.
The Setup procedure ends when the Image
Acquisition parameters are successfully
saved in the reader memory, the Setup
LED will stop blinking and Matrix 120™
emits 3 high pitched beeps.
If the calibration cannot be reached after
a timeout of about 5 (five) seconds,
Matrix 120™ will exit without saving the
parameters to memory, the Setup LED will
stop blinking and in this case Matrix 120™
emits a long low pitched beep.
Figure 8 - X-PRESS interface:
Setup function
1. Enter the Learn function by pressing and
holding the X-PRESS push button until the
Learn LED is on.
2. Release the button to enter the Learn
function. The Learn LED will blink until
the procedure is completed.
The Learn procedure ends when the
Image Processing and Decoding parame-
ters are successfully saved in the reader
memory, the Green Spot is activated, the
Setup LED will stop blinking and Matrix
120™ emits 3 high pitched beeps
1
.
If the autolearn cannot be reached after a
timeout of about 3 (three) minutes,
Matrix 120™ will exit without saving the
parameters to memory, the Learn LED
will stop blinking and in this case Matrix
120™ emits a long low pitched beep.
1. The Learn procedure will not recognize
the following symbologies: Postal Codes,
Pharmacode, MSI, Standard 2 of 5, Matrix
2 of 5
Figure 9 - X-PRESS interface:
Learn function