Datalogic Magellan 9300i, Руководство по продукции

Страница: 285 / 520

Enter/Exit Programming Mode
Product Reference Guide 273
Setting Label ID
This feature allows the setting of custom Label ID character(s) for each available
symbology type if other than the default Label ID is desired.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code for the desired symbology below. You’ll need to cover
any unused bar codes on this and the facing page to ensure the scanner
reads only the bar code you intend to scan.
3. Scan the appropriate digits from the Keypad on page 461 in Appendix C
that represent the desired Label ID characters; entered as two hex pairs. A
table containing the ASCII Character Set and their corresponding Hex Val-
ues is available in the inside back cover of this manual. ASCII parameters
must be input by scanning a pair of hexadecimal digits for each character.
Thus, to set a two-character value of AB, bar codes containing the digits
‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable range for this option
is any hex value from 00 to FF.
Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar code.
1D Symbologies
Default Label ID for this symbology is:
41 = A
Set UPC-A Label ID
Set UPC-A 2-Digit Supplemental Label ID
Default Label ID for this symbology is:
41 = A
Default Label ID for this symbology is:
41 = A
Set UPC-A 5-Digit Supplemental Label ID
Set UPC-E Label ID
Default Label ID for this symbology is:
45 = E
0024(CR)
002D(CR)
002E(CR)
0025(CR)