Datalogic Magellan 3300HSi, Руководство по продукции

Страница: 12 / 216

4 Magellan™ 3300HSi
Error Codes
If an error is detected, the scanner will sound a long low tone (for three sec-
onds) and flash its LED, indicating a failure. When this occurs, remove the top
cover and press the Scanner Push Button to hear the error code. If it is config-
ured to do so, the scanner will sound a series of beeps corresponding to the
error code and/or flash its LED simultaneous to the beeps. The table below
describes what these codes mean and what action should be taken for each.
Installation
For comfortable slide-through scanning, mount the scanner level with the
countertop. Follow these steps for flush installation:
1. Decide the best situation for the scanner by considering...
• Proximity to the user. Verify that checkstand features allow the scanner
to be within easy reach of the user, without interfering with cash draw-
ers or other equipment.
• Cable routing to and from the scanner: Can cables and connected
devices be routed in such a way as to be protected from damage or tam-
pering?
• Mounting stability. Avoid placing the scanner in such a way as to subject
it to excess vibration, bumping, spillage, etc.
• Peripheral connections from the scanner, such as a handheld device.
2. The countertop must be modified to accept the scanner. At the time of this
writing, three options are available.
• Figure 3 a shows the dimensions for the opening and other details if a
shelf is to be built to support the unit.
• Figure 3 b details the cutout dimensions if an adapter fixture holding the
scanner will rest with its rim above the countertop.
NUMBER OF
LED
FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1
Configuration
Contact Helpdesk for assistance
2
Interface PCB
6 Main PCB
10 Button Error
12
Imager Module
13
Software ID Failure
14 Software Fatal Fault