Datalogic Gryphon I GD4132, Руководство по продукции

Страница: 303 / 354

Data Editing
Product Reference Guide 301
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Go to page 84 and scan the ENTER/EXIT barcode.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
(Enable as suffix) by scanning the appropriate barcode in the section
"Label ID Control" on page 84. Reference Figure 18 for Label ID positioning
options if multiple identification features are enabled.
3. Scan a barcode to select the symbology for which you wish to configure a
custom Label ID from the section "Label ID Symbology Selection" on
page 85.
4. Determine the desired character(s) (you may choose up to three) which will
represent the Label ID for the selected symbology.
5. Turn to the ASCII Chart on the inside back cover of this manual and find
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to Keypad, starting on
page 337 and scan the barcodes representing the hex characters deter-
mined. For the example given, the characters ‘3’ and ‘D’ would be
scanned. More examples of Label ID settings are provided in Table 39 .
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
6. Scan the ENTER/EXIT barcode to exit Label ID entry.
7. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 18. Label ID Position Options
OR
Prefix Su ffix L ab el ID L ab el ID B a r Code D a t a Aim ID