REFERENCES
288
GRYPHON™ I GD/GBT/GM4500
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The select-
able range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond incre-
ments.
Follow these instructions to set this feature.
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
Mode.
4. Scan the bar code: SELECT FLASH ON TIME SETTING on
.
5. Scan the appropriate two digits from the keypad in
, that represent the
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the following table for examples of how to set this
feature.
Table 19 Flash On Time Setting Examples
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
STEP
ACTION
EXAMPLES
1
Desired Setting
500ms
1,000ms
(1 sec.)
5200ms
(5.2 sec.)
9,900ms
(9.9 sec.)
2
Divide by 100
(and pad with leading zeroes to
yield two digits)
05
10
52
99
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT FLASH ON TIME SETTING
5
Scan two characters from
‘0’ and ‘5’
‘1’ and ‘0’
‘5’ and ‘2’
‘9’ and ‘9’
6
Scan ENTER/EXIT PROGRAMMING MODE
Содержание Gryphom 4500 Series
Страница 94: ...80 GRYPHON I GD GBT GM4500 CONFIGURATION IBM 46XX INTERFACE SECTION CONTENTS IBM 46xx Interface Options ...
Страница 338: ...SAMPLE BARCODES 324 GRYPHON I GD GBT GM4500 Interleaved 2 of 5 Code 32 Codabar Code 93 Code 11 12345678901231 ...
Страница 341: ...SAMPLE BARCODES PRODUCT REFERENCE GUIDE 327 2D Barcodes continued QR Code 35900G9 Micro QR Code 123456 UCC Composite ...
Страница 343: ...PRODUCT REFERENCE GUIDE 329 1 2 3 4 5 6 7 8 9 ...