Datalogic Arex 400, Руководство пользователя

Страница: 44 / 148

TECHNICAL SPECIFICATIONS
36
AREX™ 400
Table 2: Command Box connector pinout
(*) refers to Lighter™ user's manual “Setting I/O parameters” paragraph to set the signal properties
(**) refers to Lighter™ user's manual
(***) see “Input/Output specifications” on page 41
Muting Device
Sub-D, 25 pins, male, with shell.
Figure 10: Command Box Muting Device provided
Internal electric diagram
Figure 11: Command Box Muting Device electric diagram
21 GND Ground Ground reference
22 ENABLE_OUT Digital Output
This signal is used to know if the laser marker is ready to emit laser radia-
tion:
- ON when the laser marker is in READY state
23 SW_READY* Digital Output
Depending on the configuration this signal can be used in different ways:
- COMPATIBILITY: ON when a document or a sequence is running in AUTO
MODE** or WORK MODE** independently from the laser marker state. The
signal is ON regardless of whether the laser marker is ready to start a new
marking
- STANDARD: ON when a document or a sequence is running in AUTO
MODE** or WORK MODE** and the laser marker state is READY. The signal
is ON regardless of whether the laser marker is ready to start a new mark-
ing
- READY TO MARK: ON only when a document or a sequence is running in
AUTO MODE** or WORK MODE** and the laser marker state is READY. The
signal is ON only if the laser marker is ready to accept a new
START_MARKING event (loading/spooling already executed)
This signal can also be driven using Lighter™ Script engine
"IoPort.setReady (true)" function
24 GND Ground Ground reference
25 GND Ground Ground reference
PIN SIGNAL TYPE*** DESCRIPTION
CAUTION
If the Command Box Muting Device provided is connected, the laser marker
enable is bypassed
.