background image

IMPORTANT INSTRUCTIONS:

This  product  is  designed  for  retrofit  work  only 

because  the  electrical  outlet  box  cannot  be 

attached to a stud.   

WARNING: 

Before  run

ning

  12/2  w/  ground  UL  approved 

building 

wire

to  the  Recessed  Low  Voltage  Media 

Plate with 20 Amp Duplex Receptacle, be sure the 

power is off by switching the circuit breaker to off 

or removing the fuse(s).  Test the power to make 

sure

 the power is off. Be sure to install the Media 

Plate  with  Duplex  20  Amp  Receptacle  in 

accordance  with  the  National  Electrical  Code 

(NEC) local codes.  

WARNING

DataComm Electronics’ products shall be installed and used only as indicated in DataComm Electronics’ product instruction sheets.

Instruction sheets are available online at www.datacommelectronics.com.

CAUTION

For shock protection, this device must be properly grounded.

Use copper wire only with this device.

IMPORTANT INSTRUCTIONS 

Read and understand all instructions.

Follow all warnings and instructions marked on the product.

Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a

swimming pool.

SAVE THESE INSTRUCTIONS.

Instruction / Installation Sheet
Recessed Low Voltage Media Plate 

with 20 Amp Duplex Receptacle
Part # 45-0032-WH

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.DataCommElectronics.com

Parts Included: 

• Recessed Low Voltage Media Plate

• Steel Electrical Box

• 20 Amp/125 Volt Tamper Resistant Duplex Receptacle

• Four (4) Electrical Box Mounting Screws

Tools Required: 

• Drill with Phillips Bit or Phillips Head Screw Driver

• Pen or Pencil

• Sheetrock Saw or Utility Knife

• 6 Ft. Tape Measure

Use the Recessed Low Voltage Media Plate with 20 Amp Duplex Receptacle to install low voltage cables 

behind your HDTV or other display device. The plate can be installed upright or sideways 

(see Installation 

Diagram below)

.

Features of the Recessed Low Voltage Media Plate with 20 Amp Duplex Receptacle include:

• HDTV/display device plug recesses completely into the wall when plugged into the Media Plate

• 20 Amp Duplex Receptacle and Steel Electrical Box for commercial requirements

• Large low voltage pass through opening for multiple low voltage cables

Page 1 of 3

1

1

/

15

/13

Installation Diagram

Отзывы: