© 2015 Datacom Systems Inc
4
VS-10XX-F, VS-11XX-F, VS-12XX-F FASTstart Guide
1.6 Safety Notices and Warnings
These explanatory labels are included in this information for the user in accordance
with the requirements of IEC 60825.1.
WARNING
:
When used with any
Class 1 laser and LED product
s
.
(SFP+/SFP transceivers)
A class 1 laser is safe under all conditions of normal use. Invisible laser radiation may
be emitted from optical port openings when no fiber cable is connected, avoid exposure
to laser radiation and do not stare into
open optical ports.
IMPORTANT
:
Rack Mount Instructions are included here to call the attention of installation technicians to
pertinent safety and warning issues prior to the installation of the product as follows:
A. Elevated Operating Ambient — If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient. Therefore, consideration should
be given to installing the equipment in an environment compatible with the maximum ambient temperature
specified.
B. Reduced Air Flow — Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
C. Mechanical Loading — Mounting of the equipment in the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
D. Circuit Overloading — Consideration should be given to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits might have on over-current protection and supply
wiring. Approp
riate consideration of equipment nameplate ratings should be used when addressing this
concern.
E. Reliable Earthing — Reliable earthing of rack-
mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to the branch circuit (e.g.
use of power strips).
E. Reliable Earthing — Reliable earthing of rack-
mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to the branch circuit (e.g.
use of power strips).
F
.
No user servicable parts inside. Do not open the product. Product must be returned to factory for repair.
