Datacolor 9020-0129, Руководство по эксплуатации

Страница: 24 / 127

Datacolor CONDITIONER™ (MB2) 06/2017 page 24/126
4.3.1 Automatic fresh water supply via water pipe
An enclosure inside the cabinet contains the connection kit for freshwater and wastewater. Install the
freshwater connection using either the enclosed water hose or another pressure-resistant one. To ac-
complish this, remove the cover of the freshwater connection “IN” (6) on the rear of the cabinet. Protect
both ends of the hose with two of the four supplied hose clamps.
Before turning on the cabinet, check the connection for leaks. Water supply is automatically effected via
the freshwater connection “IN” (6).
As the appliance only lets in water when required, there is no continuous water flow.
•
Supply pressure 1 to 10 bar when connecting to a water pipe
•
Water type: deionized (demineralized) water
•
Water intake temperature NOT below +5 °C / 41 °F and not exceeding 40 °C / 104 °F .
•
The water intake should be provided with a shut-off slide or water-tap.
•
For the water supply, fix the delivered adapter with hose olive on the thread at the rear of
the cabinet.
•
Protect the water supply at one side with the supplied hose clamp.
The connection kit for connecting the cabinet to the water main enclosed with the cabinet includes a
protective device against flooding caused by burst water hoses. Items supplied:
Hose burst protection device.
2 hose nozzles with screwing
4 hose clamps
6m water hose (PVC black, 12 mm (½’’) inner diame-
ter), which should be cut into 2 accordingly, for the
feed hose and drain.
Pressure-resistant up to 10bar, heat resistant up to
95 °C /
203 °F .