CE870 Instant Issuance System User’s Guide
35
Load the Topping Foil Cartridge
1.
Prepare the topping foil cartridge and topping roll.
a.
Unlock and open the embosser supplies access
door and remove the topping foil cartridge. The
topping foil cartridge is on the left as you face the
embosser.
b.
Place the topping foil cartridge on a flat surface
with the spindles facing up.
c.
Remove the used topping foil spools from the
cartridge and discard them according to your
site’s security procedures.
d.
Remove the topping foil from its package.
2.
Secure the supply spool into the spindle.
a.
Match the keyed pattern of the blue supply spool
hub with the right-side spindle.
b.
Push the supply spool into the spindle until it
clicks securely into place.
3.
Roll out and route the foil around the rollers on the
topping foil cartridge. A diagram on the cartridge
shows the correct routing pattern.
4.
Secure the silver take-up spool into the spindle.
a.
Match the keyed pattern of the take-up spool
hub with the left side spindle.
b.
Push the take-up spool into the spindle until it
clicks securely into place.
5.
Turn the take-up spool one full turn
counterclockwise to take up foil slack.
Supply
Spool
Take-up
Spool
Содержание CE870
Страница 1: ...Datacard CE870 Instant Issuance System User s Guide January 2017 Part No 527260 001 Rev H ...
Страница 8: ...viii ...
Страница 14: ...2 Introduction ...
Страница 26: ...14 About the System ...