7
Assembly
1. Attach/screw the tripod
’s own quick release
plate to the screw holes on the base of the
TP-600 ENG Prompter rail,
item A
.
The long slot will be to the rear of the
camera position and the four holes in the rail
will be towards the lens of the camera.
Tip:
Add a second screw (not supplied)
through the quick release plate. This to stop
the Prompter Frame from being able to spin
on top of the quick release plate.
2. Now slide and secure the tripod plate, with
prompter rail,
item A,
onto the head of the
tripod or dolly.
3. Use the hand screws
item C,
to secure the
lower part of the ENG Prompter Frame
item
B
in place using the counter sunk holes in
the main part of the frame
item A
.
Note:
There should be two holes left free in
front of this mounting position for the Glass
frame.
4. There are four adhesive Velcro straps
packed inside the Snood/Hood,
item I
. Peel
off the white paper backing before applying
these straps to the Glass Frame,
item G
.
Apply the two long Velcro strips to the Glass
Frame edges on the Left side and Right
side. Then apply the two smaller Velcro
strips to the Bottom Left and Right sides of
the Glass Frame edge.
Be careful not to cover any screws and
keep them straight.
