Data Translation DT351, Руководство по началу работы

Страница: 17 / 52

Preparing to Use a DT351 Board
9
2
2
2
2
2
2
2
2
2
Installing the Software
To install the software, perform the following steps:
1. Insert the Data Acquisition OMNI CD into your CD-ROM drive.
2. Click Start from the Task Bar, then click Run.
The Run dialog box appears.
3. In the Command Line edit box, enter D:\LAUNCH.EXE.
If your CD-ROM is not in drive D:, enter the letter of the drive where
your CD-ROM is located.
4. Click OK.
The Data Acquisition Software setup program starts.
5. Click Install Products.
A list of software products that you can install appears.
6. Click Device Drivers.
The DT-Open Layers Data Acquisition software wizard appears.
7. Click Next.
You are prompted for the destination location.
8. Either change the directory path and/or name using Browse or
accept the default directory, then click Next.
You are prompted to select the software components to install.
9. Select DT351, then click Next.
You are prompted for the program folder name.
CAUTION:
This version of the software provides WDM-compliant device drivers
and DLLs (version 5.0 or greater). Other Data Translation boards may
not provide WDM-compliant files.
You cannot use a DT351 board at the same time as another Data
Translation board unless both devices provide WDM-compliant files.