Data Translation DT340, Руководство по началу работы

Страница: 17 / 70

Preparing to Use a DT340 Board
9
2
2
2
2
2
2
2
2
2
Installing the Software
To install the software, perform the following steps:
1. Insert the Data Acquisition OMNI CD into your CD-ROM drive.
2. Click Start from the Task Bar, then click Run.
The Run dialog box appears.
3. In the Command Line edit box, enter x:\LAUNCH.EXE (where x
is the letter of your CD-ROM drive).
4. Click OK.
The Data Acquisition Software setup program starts.
5. Click Install Products.
A list of software products that you can install appears.
6. Click Device Drivers.
The DT-Open Layers Data Acquisition software wizard appears.
7. Click Next.
You are prompted for the destination location.
8. Either change the directory path and/or name using Browse or
accept the default directory, then click Next.
You are prompted to select the software components to install.
CAUTION:
This version of the Data Acquisition OMNI CD provides
WDM-compliant device drivers and DLLs (version 5.0 or greater) for
the DT340 board. Other Data Translation boards/modules may not
provide WDM-compliant drivers.
You cannot use a DT340 board at the same time as another Data
Translation board/module unless both devices provide
WDM-compliant drivers.