Data Translation DT330 Series, Руководство по началу работы

Страница: 17 / 60

Preparing to Use a DT330 Series Board
9
2
2
2
2
2
2
2
2
2
Installing the Software
To install the software, perform the following steps:
1. Insert the Data Acquisition OMNI CD into your CD-ROM drive.
2. Click Start from the Task Bar, then click Run.
The Run dialog box appears.
3. In the Command Line edit box, enter x:\LAUNCH.EXE (where x
is the letter of your CD-ROM drive).
4. Click OK.
The Data Acquisition Software setup program starts.
5. Click Install Products.
A list of software products that you can install appears.
6. Click Device Drivers.
The DT-Open Layers Data Acquisition software wizard appears.
7. Click Next.
You are prompted for the destination location.
8. Either change the directory path and/or name using Browse or
accept the default directory, then click Next.
You are prompted to select the software components to install.
9. Select DT330 Series, then click Next.
You are prompted for the program folder name.
CAUTION:
This version of the Data Acquisition OMNI CD provides
WDM-compliant device drivers and DLLs (version 5.0 or greater) for
the DT330 Series boards. Other Data Translation boards/modules
may not provide WDM-compliant drivers.
You cannot use a DT330 Series board at the same time as another
Data Translation board/module unless both devices provide
WDM-compliant drivers.