Data Translation DT3145, Руководство по началу работы

Страница: 44 / 60

Chapter 5
36
Using DT-AcquireCL
Note: For more information about DT-AcquireCL, click Help from
the DT-AcquireCL main menu, then click DT-AcquireCL Help
Topics .
To use DT-AcquireCL, perform the following steps:
1. Connect a Camera Link camera to the Camera Link connector
using a Camera Link cable (such as the EP327 cable, available
from Data Translation). Connect digital input, digital output,
external trigger input, strobe output, and/or +5 V output signals,
as needed, to the STP15 using the EP337 cable. Refer to
Chapter 4
starting on page 25 for more information.
2. From the DT-AcquireCL main menu, select File | Select Device .
3. From the Select Device dialog box, select the alias that you gave
to the DT3145 board when you configured the device driver, then
click
OK .
4. Select Setup | Timeout , then enter a value to indicate when the
acquisition should timeout if a valid video signal is not present.
5. Select Setup | Configure to open the Properties dialog box.
6. To use an existing device configuration file, select the Config tab,
highlight the file that you want to use, click
Load , then click OK .
Click OK to close the Properties dialog box, then continue at
step 14.
To configure the DT3145 frame grabber board to match the
settings of your camera, continue at step 7.