Data Translation DT3010 Series, Руководство по началу работы

Страница: 56 / 142

Chapter 5
46
• When first installing the board, it is recommended that you do
the following:
−
Wire a function generator or a known voltage source to analog
input channel 0 (use the differential configuration).
−
Wire an oscilloscope or voltage meter to analog output
channel 0.
−
Wire a digital input to digital I/O Port A.
−
Wire a external clock or scope to counter/timer channel 0.
−
If you have not done so already, install the DT3010 Series
software.
−
Run the Quick Data Acq application (described in Chapter 6
starting on page 105 ) to verify that the board is operating
properly.
−
Once you have determined that the board is operating
properly, wire the signals according to your application’s
requirements.
Considerations When Using 5B or 7B Series Signal
Conditioning Modules
When using a DT3010-268 with an STP268-EC screw terminal panel
and a 5B or 7B Series signal conditioning backplane and modules,
keep the following considerations in mind:
• The 7BP04-1 backplane maps to single-ended analog input
channels 0 to 3.
• The 5B08 and 7BP08-1 backplanes map to single-ended analog
input channels 0 to 7.