Display User Manual
DDJ07850001
26-Jan-04
Page 4
2
Hardware
2.1
Unpacking
Carefully remove the items from their package and store the packaging safely. After unpacking,
inspect the contents for any damage that may have occurred during shipment. In the event of
damage, refer to the '
Technical Support'
section of this manual.
2.2
Installation
The Display Board is supplied in two sections, Unit 1 and Unit 2. The Power and Serial cables from
Unit 1 to Unit 2 must be connected at installation. Refer to Figure 1 for wiring instructions. Mount the
Board securely and connect the cables as shown in the Figure below.
Figure 2.1 – System Configuration
Graphic Board Display
32 x 96 Pixels
Unit 1 (Master)
Unit 2 (Slave)
INSTALLATION INSTRUCTIONS
1.
Remove contents from Crate.
2.
Mount the Displays securely.
3.
Connect the SERIAL, TEMP, POWER and Common GROUND cables from Unit 1 to same Cables on Unit 2.
4.
Connect same color wires on POWER Terminal Blocks, i.e. Black to Black (LIVE), White to White (NEUTRAL) and
Green to Green (EARTH). Thin Black wire is Common Ground.
110/120V AC
POWER IN
FUSE
SERIAL IN
from PC via
RS485 Box
Warning: Do NOT power up the Display
Board until all cabling is connected.
Power Consumption for Display: 500W
Control PC with GRAFIT
Software
RS232 Cable
RS485 Box
TEMP