Dasan V8102, Руководство пользователя

Страница: 94 / 910

UMN:CLI
User Manual
V8102
94
5.5 Tunneling
This chapter contains commands for IP tunneling.
5.5.1 Opening Tunnel Interface Mode
You can create a tunnel interface and then configure the logical interface for your IP tun-
nel.
To open Interface tunnel mode, enter the interface tunnel command, then the system
prompt will be changed from SWITCH(config)# to SWITCH(config-if[tunnel#])#.
Command Mode Description
interface tunnl <0-1023>
Global
Interface
Opens Interface tunnel mode.
0-1023: tunnel interface number.
5.5.2 Checksum Feature Set
To enable a checksum feature for the tunnel, use the following command.
Command Mode Description
tunnl checksum
Interface
Enables a checksum feature.
no tunnel checksum Disables this feature.
Make sure to configure the tunnel checksum feature before configuring the tunnel source
and destination.
Make sure to configure the tunnel checksum on both ends of the tunnel.
5.5.3 Tunnel Address Configuration
To specify a tunnel source address in an IPv4 portion, use the following command.
Command Mode Description
tunnl source A.B.C.D
Interface
[Tunnel/GPON]
Specifies a tunnel source address.
A.B.C.D: tunnel source IPv4 addresss.
no tunnl source Deletes the configured address.
To specify a tunnel destination address in an IPv4 portion, use the following command.
Command Mode Description
tunnl destination A.B.C.D
Interface
[Tunnel/GPON]
Specifies a tunnel destination address.
A.B.C.D: tunnel destination IPv4 addresss.
no tunnl destination Deletes the configured address.
i