10
Ordercode: D2608 / D2609
PSS-108 MKII / PSS-110 MKII
Installation
Remove all packing materials from the PSS-108/110 MKII. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate an 115V specification product on 230V power, or vice versa.
Connections:
01)
Turn off the
power (31)
switch.
02)
Connect the PSS to your other devices you plan on using.
CAUTION: Be sure that the power is off, when connecting the cables.
Operating on AC power
●
Make sure the
power (31)
switch is in Off (middle) position and connect the power cable.
●
Switch the
power (31)
switch in position I to run the PSS. The
power (16)
LED will light red.
Operating on battery power
●
Do not connect the power cable.
●
Switch the
power (31)
switch to position I to run the device.
●
Switch the
power (31)
switch to position 0 if you’re pausing, to save your batteries.
●
If the batteries are fully charged, the PSS can run on battery power for approximately 3-5 hours,
depending on the volume level.
●
If the batteries run low, the unit switches off.
Charging the built in batteries
●
Make sure the
power (31)
switch is in Off (middle) position and connect the power cable.
●
Switch the
power (31)
switch to position II to charge the PSS’s internal batteries.
●
While the PSS is charging, the red
recharge (15)
LED will light red.
●
Charge the batteries for at least 8 hours. If the batteries are fully charged, the red
recharge (15)
LED lights up continuously.
Содержание PSS-108 MKII
Страница 16: ...2014 DAP Audio...
