Ordercode: D3507
PRA-62 2 x 25W
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer’s instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
If the speakers do not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the speakers, the fuse.
01)
Power supply. Check if the unit is plugged into an appropriate power supply.
02)
The speakers. Return the PRA-62 to your DAP Audio dealer.
03)
The fuse. Replace the fuse. See page 8 for replacing the fuse.
04)
If all of the above appears to be O.K., plug the unit in again.
05)
If you are unable to determine the cause of the problem, do not open the PRA-62, as this may
damage the unit and the warranty will become void.
06)
Return the device to your DAP Audio dealer.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
Product Specification
Input voltage:
230V AC, 50 Hz
Power consumption:
2 x 25W RMS
Impedance:
8 Ω
Woofer:
6,5” Mica cone rubber edge
Tweeter:
12,6 mm
Mylar dome:
1,49 OZ magnet
Magnet:
10 Oz
Frequency range (-10 dB):
50 Hz – 20 kHz
Controls:
Gain, Bass, Treble
Connections:
RCA line connector IN, IEC power IN, speaker cable connector IN
Color:
Black
IP rating:
IP20
Fuse:
F1AL/250V
Dimensions:
190 x 215 x 290 mm (LxWxH)
Weight:
7,2 kg
Design and product specifications are subject to change without prior notice.
9
Содержание PRA-62
Страница 11: ...Ordercode D3507 PRA 62 2 x 25W Dimensions 10...
Страница 12: ...2015 DAP Audio...
