DAPAudio IMIX-5.3, Руководство пользователя, Страница: 10 / 16

9
12. Zone assign buttons
Use these 3 buttons to assign the corresponding channel to one or more zones.
13. Channel fader
A logarithmic 50mm fader, which controls the volume of the corresponding channel. The overall volume
is set with the master control.
14/15/16. Equalizer section (zone A/B/C)
The zone equalizer section allows shaping of the outgoing audio
signal. All input channels are fitted with 3-band EQ. The
high (15) and
low (16) shelving controls have their frequencies fixed at 10 KHz and
100 Hz respectively. The mid (14) range control has a peaking
response frequency at 1 KHz. All 3 bands have up to 12dB cut and
boost, with a centre detent for. Turning the equalizer control to the
right amplifies the frequency range; turning to the left attenuates the
signal. Minor changes to an equalizer control usually produce the best
results. Try to avoid excessive enhancement of the mid band.
17. Aux mini jack in connector
Unbalanced stereo mini jack aux input for connecting a line/phones
level device. Use the
phone/Line (21) button to set up this input for
connecting either headphone or line level output devices.
18. Power LED
Indicates that the IMIX-5.3 is switched on.
19. Power on/off switch
Do not supply power before the whole system is set up and connected properly.
20. Aux RCA in connectors
Unbalanced stereo RCA aux input for connecting a line/phones level device. Use the phone/line (21)
button to set up this input for connecting either headphone or line level output devices.
21. Phone/line button
Use this button to configure both aux (17,20) inputs for either line level or headphone level.
22. Output signal VU-meter (zone A/B/C)
This meter is a multi-step LED. The accurate level indication allows you to monitor the output signal level
at anytime, and match with other devices.
23. Level control (zone A/B/C)
Allows you to adjust the output signal to the zone A/B/C (31-36, 45) outputs.
24. Balance control (zone A/B/C)
By using the bal(ance) control you can adjust the balance between the left and the right channel.
25. PFL button
The PFL button (pre fade listening) is designed to route the corresponding zone to the headphone
section. It is possible to assign more than one zone simultaneous to the PFL bus.
26. Zone assign buttons
Use these 3 buttons to assign the aux channel to one or more zones.
27. Headphones level control
This control allows you to adjust the headphones’ volume.