DAPAudio D1476B, Руководство пользователя

Страница: 19 / 32

18
Order code: D1476B
EDGE EBS-1
4. Scan
In this menu you can automatically scan the entire frequency range, in order to find and choose the
unused frequency. By doing so, you can avoid signal distortion.
01)
Turn the control (13) until the display shows:
02)
Press the control (13) to enter. The display will show:
03)
The device will now automatically scan the entire frequency range (606–668 MHz). This process may
take up to 2 minutes.
04) Once the scanning is finished, turn the control (13) to select the desired frequency. Choose the least
used frequency in order to avoid signal distortion.
05) Press the control (13) to confirm.
5. Sync
In this menu you can pair the receiver with the transmitter.
01)
Turn the control (13) until the display shows:
02)
Press and hold down the power button (03) on the transmitter for 2 seconds to switch it ON.
03) Place the transmitter close to the receiver’s display (10–20 cm). Make sure that you point the IR
sensor (09) on the transmitter at the IR sensor (15) on the receiver.
04) Press the control (13) to pair the devices. The IR sensor (15) on the receiver will blink several times. The
devices are now paired and ready for use.