Dantherm Silencio 600, Руководство по обслуживанию

Страница: 20 / 87

20
Set points
Introduction
This section gives you information about the set points.
The following topics will be described:
• Factory settings
• How to change set points
General
This section describes how to change set points on a stand alone unit without any of
the accessories DanView or DanLink. Changing settings with DanView or DanLink
please refer to the manuals for these products.
Factory settings
The factory settings are as follows:
Set point Factory Range
Heater 5 °C 0 °C to15 °C
Active cooling 27 °C 20 °C to 40 °C
How to change
Using the dials on the front of the control board you are able to change the above
settings.
Limitations
Limitations in set points: Please notice that the minimum difference between cooling
and heating set point must be 10 degrees or more to avoid
fighting between active cooling and heating.
For further information about the set point settings, please see section “Users guide”,
page 31.