Dantherm CC 3000, Руководство по обслуживанию

Страница: 26 / 40

26
Operation : Home menu level
Self test function can be used for diagnostics of system.
It runs through either
•
an automatic sequency where all components are activated or
• a manual function of each component
Automatic self test:
1. Use “stop/start” for enabling/disabling automatic sequency.
2. Perform the visual check, while the different components are activated one by one.
(Time duration for activation of each component is 2 minutes, which should be sufficient
for the installer to perform the visual check.)
3. Note down the status of the different components.
4. Test steps can be bypassed by pressing
DOWN key.
Manual self test:
1. Enable each component manually, if only relevant outputs have to be checked.
2. Perform the visual check, while the components are activated individually.
3. Note down the status of the different components.
4. Set back to “None” (normal mode), when visual check has been completed.
List of components:
• Dampers open
• Fans (max RPM 75% duty cycle)
• Dampers close
• Heater
• Air Con 1
• Air Con 2
• Alarm 1-10 (The corresponding alarm output will be toggled)
Enter sub menu, where system settings can be done.
All vital parameters for the system can be set in this menu.
•
To enter this menu, password is needed. (default password is: 0000)
See sub menu on page 27.
Following product information is available under the information menu item.
•
FW. (Controller firmware version)
• MAC Adress
If you have entered the corresponding information you will also find:
•
SN. (Controller serial number)
• FB 1. (information or serial number of Free cooling unit 1)
• FB 2. (information or serial number of Free cooling unit 2)
• A/C 1. (information or serial number of air conditioner 1)
• A/C 2. (information or serial number of air conditioner 2)
Self test
System settings
System
Information