41071-1199 <90-00037>
P
AGE
13
INSTALLATION
1.
Slide a knife blade, thin screwdriver, or similiar tool carefully under
the lens between the case and the lens. Approximately 1/8" is suffi-
cient.
2.
Using a twisting motion, gently pry up on the lens until it pops off.
3.
Pull out the defective lamp.
4.
Insert new lamp.
5.
Press lens back on.
The lamps are type 48PSB and can be ordered from your local
electronics store or from Dantel using part number A25-00020-00.
OPERATION
T
o make sure the lamps and audible alarm are working, push
the AUDIO-VISUAL TEST button on the remote switch box.
To enable the audible alarm, put the ON/ACO switch on the
remote switch box in the ON position.
To disable the audible alarm, put the ON/ACO switch in the
ACO position.
To adjust the volume of the audible alarm, turn the screw on the
right side of the alarm display box.
TECHNICAL SPECIFICATIONS
DESCRIPTION
Input Voltage
Relay Coil
Nominal Power
Resistance
Relay Contact Current Rating
Physical Dimensions
Alarm Display Box
Remote Switch Box
Wire Wrap Pin Dimensions
Diameter
Length
Weight
VALUE
-48 VDC
518 - 580 mW
1070 ohms +/-10%
2 Amps (maximum)
7.9"H x 4.7"D x 3.5"W
2.6"H x 1.4"D x 2"W
0.045" square
3/4"
2 lbs.
