P
AGE
10
44210/49210-0798 <90-00025>
F
IG
. 3 - E
XAMPLE
A
PPLICATION
, H
AYES
TM
M
ODE
APPLICATION INFORMATION
INSTALLATION
V
erify that the proper switch and strap settings have been
made. Refer to Table A and Figs. 5-8.
Wiring
In most cases, the 56-pin edge connector is prewired at the
factory. If custom wiring is required, refer to Fig. 9 for module
edge connector pin designations or contact Dantel. Wire the
connector in the shelf or housing as required.
Subassembly Mounting
The front panel plug of the 44210 is removable to allow the
subassembly front panel to appear in the front panel cutout. The
optional 49210 subassembly replaces a subassembly bypass card
that is plugged into connector J5 of the 44210. Four screws must
be removed prior to mounting the 49210 on connectors J4, J5,
and J6. Refer to Fig. 4. After mounting the 49210 on the 44210
module, replace the same four screws to hold the subassembly
securely in place.
N
OTE
:
If a bypass card is installed in
the place of the 49210 Two-line
Interface, use only line 1 (pins 41
and 42).
Public Switched
Telephone Network
(PSTN)
4
4
2
1
0
4
4
2
1
0
SERIAL RS-232
SERIAL RS-232
MODEM TONES
MODEM TONES
