19
Software Installation
w w w . t e c n a r e . c o m
DAV-4x500 Amplifier | rev.:1.1
DAV-4x500
4.3. Software interface description
Fig. 14 Main interface software
4.3.1.
Module of main interface of the software
1. Menu
2. Scan
3. Setting
4. Link
5. Device List
6.
Module
7.
Module function interface
8. List of input and output channels
9. Local IP address
4.4. Initial Interface
1.
As shown in the figure 16, make click to switch
the device between POWER ON and
STANDBY. Green is POWER ON and
yellow is STANDBY.
2.
Click to flash the display and status lights of the connected device. You can quickly
find
the
connected device from “Amplifier Device Stack”.
3. The power-on state can be selected with this buttons. After the selection the hard
switch will directly switch to the selected state.
4. Click the square buttons to quickly switch the routing status. There are four options:
stereo, parallel (mono), bridge and matrix.
Fig. 16 Device Setting
IMPORTANT:
Some connection methods do not support multiple PCs being opened at the same
time. Please keep at most one PC open this software
Содержание tecnare DAV-4x500
Страница 2: ......
