DANPHONE Futronic MKII, Руководство пользователя

Страница: 21 / 65

Page 21 of 65
The test can also be performed over the dummy load inside the test box. If so, use the short
coax cable supplied with the test box and connect like this:
Select
“VHF power test”
on the test box and press
“OK”
.
Then, activate the transmitter and keep it activated while selecting
“Meas”
or
“Cont”
.
In the Meas (= Measure) mode, the test box will perform and display a single power
measurement and store it in the memory.
In the Cont (= continue) mode, the test box will continue taking measurements until pressing the
EXIT button. Cont readings are not stored, but the feature can be used e.g. for
checking/adjusting the antenna.
Example of Printout from the Memory:
VHF # 1 Time/date: 08:18:16 / 21-11-2011
Power Measure Fwd: 20.3 Watt Rev: 0.1 Watt VSWR 1.16
VHF Frequency test
In this mode you can decide whether you wish to perform a frequency test only or a
simultaneous frequency and power test.
To measure the frequency only, use this setup:
On the test box, select
“Frequency test”
and the preferred frequency range. Then press
“OK”
and activate the transmitter. Select
“Meas”
or
“Cont”
to start measuring.
In the Meas (= measure) mode the test box will perform and display a single frequency
measurement and store it in the memory.
In the Cont (= continue) mode the test box will continue taking measurements until pressing the
EXIT button stops it. Cont readings are not stored, but the feature can be used e.g. for
checking/adjusting the antenna.
ANT.
VHF TRANSMITTER
ANT.
VHF TRANSMITTER