Dannmar DT-50, Инструкция по установке и эксплуатации

Страница: 31 / 84

DT-50 and DT-50A Tire Changer
31
P/N 5900260 — Rev. A1 — Dec. 2020
Assist Tower and Arm (DT-50A Only)
This section applies to DT-50A only. The Assist Arm supports the Assist Tower which holds two
different Tools to assist in the dismounting, mounting, and inflation of Tires.
The Assist Tower may be moved manually around the Tire. The Assist Tower may also be moved up
and down using the pneumatic control on the Tower.
The components of the Assist Tower are:
• Assist Arm . Supports the Assist Tower and Control.
• Control . Used to move the Assist Tower up and down.
• Assist Tower . Consists of a pneumatic cylinder, its control, and tools.
There are two Tools that may be attached to the Assist Tower:
–
Assist Tower Block
.
Used to hold down the Top Bead during the mounting/demounting
process.
– Restraint Tool
.
This Tool slides onto the Assist Tower Block and is used in two ways. First,
when clamping a Tire with hard sidewalls for demounting, use the Restraint Tool to push the
Wheel down firmly against the Turntable. Pushing the rim against the turntable aides in external
clamping. Second, when inflating a Tire, use the Restraint Tool to hold the Wheel in position.
Using the Assist Tower (DT-50A Only)
This section applies to DT-50A only.
•
The Assist Tower is moved into position
manually, then the tool is lowered using the
pneumatic toggle switch on the tower as shown
below.
• Push the toggle down to lower the tool to the
Tire.
• Push the toggle up to raise the tool away from
the Tire.