Danfoss VLT MSD 510, Руководство по эксплуатации

Страница: 42 / 246

3.8 Cables
3.8.1 Hybrid Cable
Pre-configured hybrid cables are used to connect the decentral servo drives (when used) to the Decentral Access Module (DAM 510).
There are 2 types of hybrid cables that are available with both angled and straight M23 connectors:
• Feed-in cable for connecting the 1st ISD 510/DSD 510 servo drive of a group to the connection point on the Decentral Access
Module (DAM 510).
• Loop cable for connecting the ISD 510/DSD 510 servo drives in daisy-chain format in an application.
Both these cables are provided by Danfoss and are available in various lengths. See the VLT™ Servo Drive System ISD 510, DSD 510,
MSD 510 Design Guide for further information.
Both ends of the loop cable are fitted with M23 connectors.
The feed-in cable is fitted with an M23 connector at the output end for connection to the 1st ISD 510/DSD 510 servo drive. At the input
end it is pigtailed and the connectors are mounted on the corresponding terminals on the Decentral Access Module (DAM 510).
Table 9: Hybrid Cables
Cable type Shielded/unshielded Notes
Feed-in cable Shielded Hybrid cable (overall shield with additional fieldbus and safety section shield).
Loop cable
NOTICE
-
Hybrid cables are available in 2 cross-sections: 2.5 mm
2
(15 A) and 4 mm
2
(25 A). See the VLT
®
Servo Drive System ISD 510,
DSD 510, MSD 510 Design Guide for further information.
NOTICE
Minimum bending radius
-
The maximal number of bending cycles is 5 million at 7.5 x cable diameter (15.6 mm).
-
Permanently flexible: 12 x cable diameter.
-
Permanently installed: 5 x cable diameter.
3.8.2 Ethernet Cable
Table 10: Ethernet Cable Recommendations
Specification
Ethernet standard Standard Ethernet (in accordance with IEEE 802.3), 100Base-TX (Fast Ethernet)
Cable type S/FTP (shielded foiled twisted pair), ISO (IEC 11801 or EN 50173), CAT 5e or 6
System Description
Operating Guide | VLT® Multiaxis Servo Drive MSD 510 System
AQ262450196490en-000101 / 175R1170
42 | Danfoss A/S © 2019.10