•
Everyone who uses Danfoss products in any manner must read and understand the corresponding safety regulations and the
description of the intended use.
•
Do not alter hardware from its original state.
•
Do not reverse-engineer software products or alter their source code.
•
Do not install or operate damaged or faulty products.
•
Ensure that the products are installed in conformance with the regulations mentioned in the documentation.
•
Observe any specified maintenance and service intervals.
•
Comply with all protective measures.
•
Only fit or install the components described in this operating guide. Third-party devices and equipment may be used only in
consultation with Danfoss.
2.6.1 Prohibited Application Areas
The servo system may not be used in the following application areas:
•
Areas with potentially explosive atmospheres.
•
Mobile or portable systems.
•
Floating or airborne systems.
•
Inhabited facilities.
•
Sites where radioactive materials are present.
•
Areas with extreme temperature variations or in which the maximum rated temperatures may be exceeded.
•
Under water.
2.7 Forseeable Misuse
Any use not expressly approved by Danfoss constitutes misuse. This also applies to failure to comply with the specified operating
conditions and applications. Danfoss assumes no liability of any sort for damage attributable to improper use.
2.8 Service and Support
Contact the local service representative for service and support.
Safety
Operating Guide | VLT® Multiaxis Servo Drive MSD 510 System
AQ262450196490en-000101 / 175R1170
22 | Danfoss A/S © 2019.10
Содержание VLT MSD 510
Страница 1: ...Operating Guide VLT Multiaxis Servo Drive MSD 510 System...
Страница 2: ......
