Danfoss VLT MCD 600, Руководство по эксплуатации, Страница: 86 / 140

Parameter group number Parameter group name Default setting
36-2 Flow Sensor Soft Trip and Log
36-3 Depth Sensor Soft Trip and Log
36-4 High Pressure Soft Trip and Log
36-5 Low Pressure Soft Trip and Log
36-6 High Flow Soft Trip and Log
36-7 Low Flow Soft Trip and Log
36-8 Flow Switch Soft Trip and Log
36-9 Well Depth Soft Trip and Log
36-10 RTD/PT100 B Soft Trip and Log
40 Ground Fault
40-1 Ground Fault Level 0 A
40-2 Ground Fault Delay 00:01 (mm:ss)
40-3 Ground Fault Trip Active Operating only
40-4 Ground Fault Action Soft Trip and Log
40-5 Ground Fault CT Ratio 1000:1
10.5 Parameter Group 1-** Motor Details
Table 30: 1-1 - Command Source
Option Function
Selects the command source for controlling the soft starter.
* Digital input The soft starter accepts start and stop commands from the digital inputs.
Network The soft starter accepts start and stop commands from the communication expansion card.
Remote LCP The soft starter accepts start and stop commands from the remote LCP.
Clock The soft starter accepts starts and stops as scheduled in parameters 4-1 to 4-24 .
Smart card The soft starter accepts start and stop commands from the smart card.
Smart card +
clock The soft starter accepts start commands from the smart card if they are within the operating schedule set
in
parameters 4-1 to 4-24 . A stop command from the smart card is accepted regardless of the schedule.
Timer After a start signal is received, the soft starter starts and stops the motor according to the timers set in
parameter 4-2 Run Time and parameter 4-3 Stopped Time .
Table 31: 1-2 Motor Full Load Current
Range Function
Model dependent Matches the soft starter to the FLC of the motor. Set to the FLC rating shown on the motor nameplate.
AQ262141844215en-000401 / 175R1174 82 | Danfoss A/S © 2020.12
Programmable Parameters
VLT® Soft Starter MCD 600
Operating Guide