Number
Minimum waiting time (minutes)
0–64 servo drives
10
Table 2.1 Discharge Time
NOTICE
Never connect or disconnect the hybrid cable to or from
the servo drive when the ISD 510 servo system is
connected to mains or auxiliary supply, or when voltage
is still present. Doing so damages the electronic circuitry.
Ensure that the mains supply is disconnected and the
required discharge time for the DC-link capacitors has
elapsed before disconnecting or connecting the hybrid
cables or disconnecting cables from the SAB.
2.5 Qualified Personnel
Installation, commissioning, and maintenance of the
ISD 510 servo system may only be carried out by qualified
personnel.
For the purposes of this manual and the safety instructions
in this manual, qualified personnel are trained personnel
who are authorized to fit, install, commission, ground, and
label equipment, systems, and circuits in accordance with
the standards for safety technology and who are familiar
with the safety concepts of automation engineering.
Additionally, the personnel must be familiar with all the
instructions and safety measures described in this manual.
They must have suitable safety equipment and be trained
in first aid.
2.6 Due Diligence
The operator and/or fabricator must ensure that:
•
The ISD 510 servo system and its components are
used only as intended.
•
The components are operated only in a perfect
operational condition.
•
The operating instructions are always available
near the ISD 510 servo system in complete and
readable form.
•
The ISD 510 servo system and its components are
fitted, installed, commissioned, and maintained
only by adequately qualified and authorized
personnel.
•
These personnel are regularly instructed on all
relevant matters of occupational safety and
environmental protection, as well as the contents
of the operating instructions and the instructions
it contains.
•
The product markings and identification markings
applied to the components, as well as safety and
warning instructions, are not removed and are
always kept in a legible condition.
•
The national and international regulations
regarding the control of machinery and
equipment, that are applicable at the place of use
of the ISD 510 servo system, are complied with.
•
The users always have all current information
relevant to their interests about the ISD 510 servo
system and its use and operation.
2.7 Intended Use
The components of the ISD 510 servo system are intended
to be installed in machines used in industrial environments
in accordance with local laws and standards.
NOTICE
In a domestic environment, this product may cause radio
interferences, in which case supplementary mitigation
measures may be required.
To ensure that the product is used as intended, the
following conditions must be fulfilled before use:
•
Everyone who uses Danfoss products in any
manner must read and understand the
corresponding safety regulations and the
description of the intended use.
•
Hardware must be left in its original state.
•
Software products must not be reverse-
engineered and their source code must not be
altered.
•
Damaged or faulty products must not be installed
or put into operation.
•
It must be ensured that the products are installed
in conformance with the regulations mentioned
in the documentation.
•
Any specified maintenance and service intervals
must be observed.
•
All protective measures must be complied with.
•
Only the components described in these
operating instructions may be fitted or installed.
Third-party devices and equipment may be used
only in consultation with Danfoss.
The ISD 510 servo system
may not
be used in the
following application areas:
•
Areas with potentially explosive atmospheres.
•
Mobile or portable systems.
•
Floating or airborne systems.
•
Inhabited facilities.
•
Sites where radioactive materials are present.
Safety
Operating Instructions
MG75K102
Danfoss A/S © 12/2015 All rights reserved.
11
2
2
Содержание VLT Integrated Servo Drive ISD 510 System
Страница 2: ......
Страница 101: ...Index Operating Instructions MG75K102 Danfoss A S 12 2015 All rights reserved 99...