Danfoss VLT FC 360, Руководство по конструкции, Страница: 22 / 82

The endpoints P1 and P2 are defined by the following parameters depending on choice of input.
Input Analog 53
voltage
mode Analog 53
current mode Analog 54
voltage
mode Analog 54
current mode Pulse Input 29 Pulse Input 33
P1 = (Minimum input value, Minimum reference value)
Minimum reference value
6-14 Terminal
53 Low Ref./
Feedb. Value 6-14 Terminal 53
Low Ref./Feedb.
Value 6-24 Terminal
54 Low Ref./
Feedb. Value 6-24 Terminal 54
Low Ref./Feedb.
Value 5-52 Term. 29
Low Ref./Feedb.
Value 5-57 Term. 33 Low
Ref./Feedb. Value
Minimum input value 6-10 Terminal
53 Low
Voltage [V] 6-12 Terminal 53
Low Current
[mA] 6-20 Terminal
54 Low
Voltage [V] 6-22 Terminal 54
Low Current
[mA] 5-50 Term. 29
Low Frequency
[Hz] 5-55 Term. 33 Low
Frequency [Hz]
P2 = (Maximum input value, Maximum reference value)
Maximum reference value
6-15 Terminal
53 High Ref./
Feedb. Value 6-15 Terminal 53
High Ref./Feedb.
Value 6-25 Terminal
54 High Ref./
Feedb. Value 6-25 Terminal 54
High Ref./Feedb.
Value 5-53 Term. 29
High Ref./
Feedb. Value 5-58 Term. 33 High
Ref./Feedb. Value
Maximum input value 6-11 Terminal
53 High
Voltage [V] 6-13 Terminal 53
High Current
[mA] 6-21 Terminal
54 High
Voltage[V] 6-23 Terminal 54
High Current
[mA] 5-51 Term. 29
High Frequency
[Hz] 5-56 Term. 33 High
Frequency [Hz]
Table 2.2 P1 and P2 Endpoints
Product Overview
VLT
®
AutomationDrive FC 360 Design Guide
20 MG06B202 - VLT
®
is a registered Danfoss trademark
2 2