![background image](http://html1.mh-extra.com/html/danfoss/vlt-automationdrive-fc-301/vlt-automationdrive-fc-301_programming-manual_507840350.webp)
This parameter is read-only. It shows the physical (MAC) address of the option.
5.12.2 12-1* Ethernet Link Parameters
Parameter 12-10 Link Status
Table 613: Parameter 12-10 Link Status
12-10 Link Status
Default value: [0] No link
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
This parameter is read-only. It shows the link status of the Ethernet ports. Index [0] is used for port 1, and index [1] is used for port 2.
For EtherCAT, index [0] is for the in-port, and index [1] is for the out-port.
Option
Name
Description
[0]*
No link
[1]
Link
Parameter 12-11 Link Duration
Table 614: Parameter 12-11 Link Duration
12-11 Link Duration
Default value: Size related
Parameter type: Range, Size related
Setup: All setups
Conversion index: 0
Data type: TimeDifferenceWithDateIndication
Change during operation: True
Shows the duration of the present link on each port in dd:hh:mm:ss.
Parameter 12-12 Auto Negotiation
Table 615: Parameter 12-12 Auto Negotiation
12-12 Auto Negotiation
Default value: Size related
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
Configures auto negotiation of Ethernet link parameters, for each port: ON or OFF. Link Speed and Link Duplex can be configured in
parameter 12-13 Link Speed
and
parameter 12-14 Link Duplex
.
Option
Name
Description
[0]
Off
[1]
On
Parameter 12-13 Link Speed
Table 616: Parameter 12-13 Link Speed
12-13 Link Speed
Default value: Size related
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
Forces the link speed for each prot in 10 Mbps or 100 Mbps. If
parameter 12-12 Auto Negotiation
is set to
[0] On
, this parameter is
read-only and shows the actual link speed. If no link is present, None is shown.
AU275636650261en-000101 / 130R0334
350 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide