![background image](http://html1.mh-extra.com/html/danfoss/vlt-automationdrive-fc-301/vlt-automationdrive-fc-301_programming-manual_507840339.webp)
Sets up the filter mask for PCD 4. When operating in COS (change-of-state), it is possible to filter out bits in PCD 4 that should not be
sent if they change.
5.11.4 10-3* Parameter Access
Parameter 10-30 Array Index
Table 596: Parameter 10-30 Array Index
10-30 Array Index
Default value: 0
Parameter type: Range, 0 - 255
Setup: 2 setups
Conversion index: 0
Data type: Uint8
Change during operation: True
View array parameters. This parameter is only valid when a VLT® DeviceNet MCA 104 is installed.
Parameter 10-31 Store Data Values
Table 597: Parameter 10-31 Store Data Values
10-31 Store Data Values
Default value: [0] Off
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
This parameter is used to activate a function that stores all parameter values in the non-volatile memory, this retaining changed
parameter values at power-down.
Option
Name
Description
[0]*
Off
[1]
Store all setups
[2]
Store all setups
Parameter 10-32 Devicenet Revision
Table 598: Parameter 10-32 Devicenet Revision
10-32 Devicenet Revision
Default value: Size related
Parameter type: Range, 0 - 65535
Setup: All setups
Conversion index: 0
Data type: Uint16
Change during operation: True
The DeviceNet revision number. This parameter is used for EDS file creation.
Parameter 10-33 Store Always
Table 599: Parameter 10-33 Store Always
10-33 Store Always
Default value: [0] Off
Parameter type: Option
Setup: 1 setup
Conversion index: –
Data type: Uint8
Change during operation: True
This parameter is used to select whether parameter data received via the DeviceNet option should always be stored in non-volatile
memory.
Option
Name
Description
[0]*
Off
[1]
On
AU275636650261en-000101 / 130R0334 | 339
Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide