![background image](http://html1.mh-extra.com/html/danfoss/vlt-automationdrive-fc-301/vlt-automationdrive-fc-301_programming-manual_507840198.webp)
-
Parameter 5-24 Terminal X46/9 Digital Input
Table 350: Parameter 5-24 Terminal X46/9 Digital Input
5-24 Terminal X46/9 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as those listed for
parameter 5-20 Terminal X46/1 Digital Input
.
Parameter 5-25 Terminal X46/11 Digital Input
Table 351: Parameter 5-25 Terminal X46/11 Digital Input
5-25 Terminal X46/11 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as those listed for
parameter 5-20 Terminal X46/1 Digital Input
.
Parameter 5-26 Terminal X46/13 Digital Input
Table 352: Parameter 5-26 Terminal X46/13 Digital Input
5-26 Terminal X46/13 Digital Input
Default value: [0] No operation
Parameter type: Option
Setup: All setups
Conversion index: –
Data type: Uint8
Change during operation: True
The options for this parameter are the same as those listed for
parameter 5-20 Terminal X46/1 Digital Input
.
5.6.3 5-3* Digital Outputs
N O T I C E
The following parameter is only available in FC 302:
Parameter 5-31 Terminal 29 Digital Output
The 2 solid-state digital outputs are common for terminals 27 and 29. Set the I/O function for terminal 27 in
parameter 5-01 Terminal
27 Mode
, and set the I/O function for terminal 29 in
parameter 5-02 Terminal 29 Mode
.
N O T I C E
These parameters cannot be adjusted while the motor is running.
Table 353: Digital Outputs, Function Descriptions - 1
Option
Function
[0]
No operation
Default for all digital outputs and relay outputs.
[1]
Control ready
The control card is ready.
[2]
Drive ready
The drive is ready for operation and applies a supply signal on the control card.
[3]
Drive rdy/rem ctrl
The drive is ready for operation and is in auto-on mode.
[4]
Enable/no warning
Ready for operation. No start or stop command has been given (start/disable). No warnings are
active.
[5]
Running
The motor runs, and shaft torque is present.
AU275636650261en-000101 / 130R0334
198 | Danfoss A/S © 2022.12
Parameter Descriptions
VLT AutomationDrive FC 301/302
Programming Guide