Danfoss VLT AutomationDrive FC 300 Series, Руководство по программированию, Страница: 16 / 211

Operating variable Unit
16-51 Pulse Reference
16-52 Feedback [Unit]
[Unit]
16-53 Digi Pot Reference
16-60 Digital Input
bin
16-61 Terminal 53 Switch Setting V
16-62 Analog Input 53
16-63 Terminal 54 Switch Setting
V
16-64 Analog Input 54
16-65 Analog Output 42 [mA]
[mA]
16-66 Digital Output [bin] [bin]
16-67 Pulse Input #29 [Hz] [Hz]
16-68 Freq. Input #33 [Hz] [Hz]
16-69 Pulse Output #27 [Hz] [Hz]
16-70 Pulse Output #29 [Hz] [Hz]
16-71 Relay Output [bin]
16-72 Counter A
16-73 Counter B
16-80 Fieldbus CTW 1
hex
16-82 Fieldbus REF 1 hex
16-84 Comm. Option STW hex
16-85 FC Port CTW 1 hex
16-86 FC Port REF 1 hex
16-90 Alarm Word
16-92 Warning Word
16-94 Ext. Status Word
Table 2.1
Status screen I
This read-out state is standard after start-up or initiali-
zation.
Use [INFO] to obtain information about the measurement
links to the displayed operating variables (1.1, 1.2, 1.3, 2
and 3).
See the operating variables shown in the screen below.
1.1
2
3 1.3
1.2
130BP041.10
799 RPM
Auto Remote Ramping
1 (1)
36.4 kw 7.83 A
0.000
53.2 %
Status
Illustration 2.10
Status screen II
See the operating variables (1.1, 1.2, 1.3 and 2) shown in
the screen below.
In the example, Speed, Motor current, Motor power and
Frequency are selected as variables in the first and second.
1.1
1.2
2
1.3
130BP062.10
207RPM
Auto Remote Running
1 (1)
24.4 kW 5.25A
6.9
Hz
Status
Illustration 2.11
Status screen III
This state displays the event and action of the Smart Logic
Control. For further information, see section
Smart Logic
Control .
130BP063.10
778 RPM
Auto Remote Running
1 (1)
4.0 kW 0.86 A
State: 0 off 0 (off)
When: -
Do: -
Status
Illustration 2.12
2.1.5 Parameter Set-Up
The frequency converter can be used for practically all
assignments, which is why the number of parameters is
quite large. The frequency converter offers a choice
between two programming modes - a Main Menu and a
Quick Menu mode.
The former provides access to all parameters. The latter
takes the user through a few parameters making it
possible to start operating the frequency converter.
Regardless of the mode of programming, you can change
a parameter both in the Main Menu mode and in the
Quick Menu mode.
2.1.6 Quick Menu Key Functions
Pressing [Quick Menus] The list indicates the different
areas contained in the Quick menu.
Select
My Personal Menu to display the chosen personal
parameters. These parameters are selected in 0-25 My
Personal Menu . Up to 20 different parameters can be
added in this menu.
How to Programme
VLT
®
AutomationDrive Programmming Guide
MG33ME02 - VLT
®
is a registered Danfoss trademark 15
2 2