Danfoss VACON OPTE3, Руководство по установке

Страница: 7 / 64

-
-
-
2 Safety
2.1 Safety Symbols
The following symbols are used in this manual:
D A N G E R
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
W A R N I N G
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
C A U T I O N
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
N O T I C E
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
2.2 Safety Instructions
A safety guide is included in the product delivery. Read the safety instructions carefully before starting to work in any way with the
system or its components.
The warnings and cautions in the safety guide give important information on how to prevent injury and damage to the equipment
or the system. Read the warnings and cautions carefully and obey their instructions.
W A R N I N G
SHOCK HAZARD FROM CONTROL TERMINALS
The control terminals can have a dangerous voltage also when the drive is disconnected from mains. A contact with this voltage
can lead to injury.
Make sure that there is no voltage in the control terminals before touching the control terminals.
C A U T I O N
DAMAGE TO OPTION BOARDS
Do not install, remove, or replace option boards on the drive when the power is on. Doing this can cause damage to the boards.
Switch off the AC drive before installing, removing, or replacing option boards on the drive.
N O T I C E
OPTION BOARD COMPATIBILITY
Installing an incompatible option board can damage the AC drive.
Make sure that the option board being installed is compatible with the drive.
AN338644703080en-0002 / DPD02156 | 7 Danfoss A/S © 2022.08
Safety
VACON® RS485 and CAN Bus Option Boards
Installation Guide