Danfoss VACON OPTE3, Руководство по установке

Страница: 51 / 64

A
3
2
1
3
2
1
3
2
1
B C
e3
0b
i0
81
.1
0
A Cable shield is connected directly to PE (factory de-
fault setting).
B Cable shield is connected to PE through RC.
C Cable shield is connected to PE through RC.
Illustration 36: The Settings of the Jumper X1, Cable Shield Grounding, Positions A, B, and C.
A
3
2
1
3
2
1
B
e3
0b
i0
84
.1
0
A Bus termination is ON.
B Bus termination is OFF (factory default setting).
Illustration 37: The Settings of the Jumper X6, Bus Terminal Resistor, positions A and B
6.3 The OPTC7 Option Board
6.3.1 The OPTC7 Option Board Layout
The OPTC7 option board is a DeviceNet fieldbus board that uses CAN bus as the communication layer.
A
N
M
X1
4
3
2
1
5
e3
0b
i0
91
.1
0
Illustration 38: The OPTC7 Option Board Layout
Table 15: The Connections of the Option Board
Signal Connector pin Description
V- 1 CAN GND V- isolated digital ground reference
CAN LO 2 CAN bus LO
AN338644703080en-0002 / DPD02156 | 51 Danfoss A/S © 2022.08
CAN Type and Other Fieldbus
Option Boards
VACON® RS485 and CAN Bus Option Boards
Installation Guide