Danfoss VACON NX, Инструкция по применению

Страница: 40 / 360

Index Parameter Min Max Unit Default ID Description
P2.4.8 DC braking current 0.00 I
L
A 0.7 x I
H
507 -
P2.4.9 DC braking time at stop 0.00 600.00 s 0.00 508 0 = DC brake is off at stop
P2.4.10 Frequency to start DC braking during
ramp stop
0.10 10.00 Hz 1.50 515 -
P2.4.11 DC braking time at start 0.00 600.00 s 0.00 516 0 = DC brake is off at start
P2.4.12 Flux brake 0 1
-
0 520 0 = Off
1 = On
P2.4.13 Flux braking current 0.00 I
L
A I
H
519 -
4.4.6 Prohibit Frequency Parameters (Control Panel: Menu M2 -> G2.5)
Table 20: Prohibit Frequency Parameters, G2.5
Index Parameter Min Max Unit Default ID Description
P2.5.1 Prohibit frequency range 1 low limit 0.00 320.00 Hz 0.00 509
-
P2.5.2 Prohibit frequency range 1 high limit 0.00 320.00 Hz 0.00 510 0 = Prohibit range 1 is off
P2.5.3 Prohibit frequency range 2 low limit 0.00 320.00 Hz 0.00 511
-
P2.5.4 Prohibit frequency range 2 high limit 0.00 320.00 Hz 0.00 512 0 = Prohibit range 2 is off
P2.5.5 Prohibit frequency range 3 low limit 0.00 320.00 Hz 0.00 513
-
P2.5.6 Prohibit frequency range 3 high limit 0.00 320.00 Hz 0.00 514 0 = Prohibit range 3 is off
P2.5.7 Prohibit acc./dec. ramp 0.1 10.0 x 1.0 518
-
4.4.7 Motor Control Parameters (Control Panel: Menu M2 -> G2.6)
Table 21: Motor Control Parameters, G2.6
Index Parameter Min Max Unit Default ID Description
P2.6.1
(1)
Motor control mode 0 1/4
-
0 600 0 = Frequency control
1 = Speed control
VACON
®
NXP:
2 = Open loop torque control
3 = Closed loop speed ctrl
4 = Closed loop torque control
P2.6.2
(1)
U/f optimisation 0 1
-
0 109 0 = Not used
1 = Automatic torque boost
P2.6.3
(1)
U/f ratio selection 0 3
-
0 108 0 = Linear
1 = Squared
AB296635287482en-000301 / DPD00903 40 | Danfoss A/S © 2023.02
Local/Remote Control Application
VACON® NX All-in-One
Application Guide