Danfoss VACON NX, Инструкция по применению

Страница: 190 / 360

•
•
1.0
0
20 mA
4 mA
10 mA
0.5
0 mA
12 mA
ID311 =
100%
ID311 =
200%
ID311=
50%
ID310 = 1
ID310 = 0
e
3
0
b
h
0
3
3
.1
0
A
B
Illustration 40: Analog Output Scaling
A Analog output current
B Maximum value of signal selected with ID 307
Use this formula to calculate the values:
OutputSignal = Signal
∗
Analogue Output Scale %
100 %
10.72 (ID 312) Digital Output Function
Location in the menu:
P2.3.7
(Standard Application, Local/Remote Control Application, Multi-Step Speed Control Application, PID Control Application)
P2.3.1.2 (Multi-Purpose Control Application)
Use this parameter to select the function for the digital output signal.
Setting value Signal content
0 = Not used Out of operation.
1 = Ready The AC drive is ready to operate.
2 = Run The AC drive operates (motor is running).
3 = Fault A fault trip has occurred.
4 = Fault inverted A fault trip not occurred
5 = AC drive overheat warning The heat sink temperature e70 °C.
6 = External fault or warning Fault or warning depending on parameter ID 701.
7 = Reference fault or warning Fault or warning depending on parameter ID 700 - if analog reference is 4–20 mA
and signal is <4 mA.
8 = Warning Always if a warning exists.
9 = Reversed The reverse command has been selected.
10 = Preset speed
(1)
The preset speed has been selected with digital input.
10 = Jogging speed
(2)
The jogging speed has been selected with digital input.
11 = At speed The output frequency has reached the set reference.
AB296635287482en-000301 / DPD00903 190 | Danfoss A/S © 2023.02
Parameter Descriptions
VACON® NX All-in-One
Application Guide