Danfoss VACON NX, Инструкция по применению

Страница: 16 / 360

•
•
•
•
•
•
•
•
•
•
•
•
3 Standard Application
3.1 Introduction to Standard Application
Select the Standard Application in menu M6 on page S6.2 .
The Standard Application is typically used in pump and fan applications and conveyors for which the Basic Application is too limited
but where no special features are needed.
The Standard Application has the same I/O signals and the same control logic as the Basic Application.
Digital input DIN 3 and all the outputs are freely programmable.
Extra functions:
Programmable Start/Stop and Reverse signal logic
Reference scaling
One frequency limit supervision
Second ramps and S-shape ramp programming
Programmable start and stop functions
DC brake at stop
One prohibit frequency area
Programmable U/f curve and switching frequency
Auto restart
Motor thermal and stall protection: Programmable action; off, warning, fault
The parameters of the Standard Application are explained in Chapter Parameter descriptions of this manual. The explanations are
arranged according to the individual ID number of the parameter.
AB296635287482en-000301 / DPD00903 16 | Danfoss A/S © 2023.02
Standard Application
VACON® NX All-in-One
Application Guide