Danfoss PVED-CLS, Руководство пользователя

Страница: 148 / 182

148 | © Danfoss | August 2018 AQ00000211
ENGINEERING TOMORROW
17.3 FMI LIST
In PVED-CLS the standard FMI from J1939-73 Appendix A page 130 are used as much as possible. However, in some
cases some of the reserved area FMI’s are redefined to suit the need.
The List of FMI’s used in PVED-CLS is found below:
Index Failure mode
0 0 - Data valid, but above normal operational range - Most severe level
1 1 - Data valid, but below normal operational range - Most severe level
2 2 - Data erratic, intermittent or incorrect
3 3 - Voltage above normal or short-circuit to high source
4 4 - Voltage below normal or short-circuit to low source
5 5 - Current below normal or open circuit
6 6 - Current above normal or grounded circuit
7 7 - Mechanical system not responding or out of adjustment
8 8 - Abnormal frequency or pulse width or period
9 9 - Abnormal update rate
10 10 - Abnormal rate of change
11 11 - Unknown root-cause
12 12 - Bad intelligent device or component
13 13 - Out of calibration
14 14 - Special instructions
15 15 - Data valid, but above normal operating range - Least severe level
16 16 - Data valid, but above normal operating range - Moderately severe level
17 17 - Data valid, but below normal operating range - Least severe level
18 18 - Data valid, but below normal operating range - Moderately severe level
19 19 - Received network data in error
20 20 - Data drifted high
21 21 - Data drifted low
22 22 - Message missing
23 23 - Unintended Steering
24 24 – Reserved
25 25 - Signal crosscheck failed
26 26 - No steering
27 27 - Unable to return to neutral
28 28 - Not in neutral at Power-up
29 29 - Stuck Open
30 30 - Stuck Closed
31 31 - Condition exists
Table 63
17.4 PARAMETER LIST